BONANZA metal detector Manual do Utilizador Página 5

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 13
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 4
5
Assembly & Preparation
The BONANZA is supplied boxed and ready for quick assembly by simply
attaching the two lower stem poles to the top one, tightening the collars and
attaching the coil to the lower stem section, using the plastic bolt and
friction washers supplied and tightened by hand so that coil is held at the
correct angle to the stem; the coil cable plug is inserted to the socket in the
control box and then tighten the knurled ring, taking care when winding the
cable around the stem that the cable is not strained.
The centre stem pole is of the same tube diameter as the top one and can
be left off in circumstances where a short stem is needed; it is meant for
use on steep sites, river banks, caves, ditches and similar conditions. This
configuration is also useful if the BONANZA is to be used by children and
makes it a good family metal detector that can be used by anyone in the
family.
The BONANZA is supplied with a drop in battery holder that can be used
for all types of AA size batteries, (alkaline or rechargeable); a charging
socket is provided to the battery box for connecting a charger unit. To
insert or change batteries remove any three of the thumb plastic screws
from the base lid of the battery box (the battery box is below the arm cup at
the top of the detector stem) and loosen the fourth screw. Turn the cover to
the side. Insert the 10 batteries, in their correct alignments, into the plastic
holder and make sure that all the terminals have a good electrical contact.
Locate the battery holder into the compartment, ensuring the connecting
terminals of the battery holder are in good contact with the two electric
spring loaded terminals behind the recharge socket. Do not over-tighten the
plastic thumb screws when refitting.
If you wish to use headphones (highly recommended) connect your
available set to the 6 mm jack socket on the battery box. The BONANZA
has an internal loudspeaker so headphones are not absolutely essential.
For any headphones that have a volume control, ensure that this is set to
MAXIMUM and use the BONANZA Volume knob on the control box to set
the volume level.
Vista de página 4
1 2 3 4 5 6 7 8 9 10 11 12 13

Comentários a estes Manuais

Sem comentários